IRLP Repeater test again today?

[Tom Azlin N4ZPT]

Hi Terry.

I am home today so can be in the shack for a planned test.  do you want 
to try this early afternoon, or did you already test?

Are there any special commands needed before touch toning 8568?

73, tom n4zpt

On 11/11/2011 9:20 AM, Terry Fox wrote:
> I would like to test the IRLP link again sometime today (Friday).  I
> should be home most of the day, but have some workers here replacing
> a water heater.
>
> Each time that I activate the link, it only stays up for about ten
> minutes of inactivity, then times out, so I need to coordinate the
> “test” time to make sure it is up when the test is being conducted.
>
> As an alternative, someone in AMRAD can connect the IRLP link to me
> by touch-toning my IRLP node number, 8568.  That should activate the
> link if the RF path between the IRLP hardware and AMRAD repeater is
> good.  Touch-toning 73 will disconnect the link.
>
> thanks. Terry, WB4JFI