parts hunt 10K ohm ten turn panel mount trimmer

[Chip Fetrow]

Is the panel drilled?

Why not get a standard 10 or 20 turn pot, you know, one of those roughly one inch long blue ones, and either make a circuit board for them, or just put them on pert board?  Yes, they would require a screwdriver to adjust, but maybe that is better anyway.  Knobs get turned by people who shouldn't do it.

--chip

On Aug 30, 2013, at 10:23 AM, tacos-request at amrad.org wrote:

> Message: 1
> Date: Thu, 29 Aug 2013 16:57:30 -0700 (PDT)
> From: Michael Chisena <ka2zev at yahoo.com>
> To: tacos AMRAD <tacos at amrad.org>
> Subject: parts hunt 10K ohm ten turn panel mount trimmer
> 
> ?All,
> Am in need of a couple of parts like this.
> http://www.digikey.com/product-detail/en/3059J-1-103MLF/3059J-1-103MLF-ND/3759134
> 
> It's a multi turn 10k ohm trimmer resistor intended for panel mounting.
> I don't want to buy them for $30 each unless I have to.
> Clean, used parts are ok.
> 
> Don't need a lot of wattage, this is to replace a volume control on a 'remote receivers' for NVFMA.
> One is built and on line, and the other is a pending job.
> Two would be good, more would be even better.
> 
> Thanks in advance.
> Mike
> 
> 
> Michael F. Chisena
> KA2ZEV at Yahoo.com
> 703 863 4574