<div dir="auto">Hi all hope are are well. I am hoping  my radio shack "Radio Shack" will be operational by Xmas holidays. My RF test and measurement rack is in place. <div dir="auto"><br></div><div dir="auto">I have  left over PT lumber beams and studs to make a staticast, with some sort of lightweight pulley on top and a few antennas of garden variety. </div><div dir="auto"><br></div><div dir="auto">But looking at some YouTube videos of pulleys and snatch buckles and pulley systems I wondered - would anyone be interested to talk about a DIY project / share experience for a vertically oriented   collapsible wood mast (say, 6ft to 24ft height, in several sections) with either a hand crank or a small DC motor winch, to lift a small yagi or a yard arm to height above terrain? I wondered about a tilt over setup - then realized the risks of the mast/gears  snapping when the load is just above horizontal going up. </div><div dir="auto"><br></div><div dir="auto">Alternatively a wooden  scissor lift could be fashioned to allow the entire assembly dropped to a maintenance height, so these are two designs I am considering  now that I am fortunate to have some space in front of my building within gated and  walled property. </div><div dir="auto"><br></div><div dir="auto">Heres why:</div><div dir="auto"><br></div><div dir="auto">Decades ago (1995) I tried using a heavy duty gear box and about 100ft of things GI pipe sections, without any mechanical engineering studies or training, and had three or four wire rope  stays to a thick and long pulling lever attached to the gear box. The load was lifted about 5 feet above ground and then the entire gearbox lifted out of its weighted foundation like a rubber band and it became a dangerous  projectile ... So that was the extent of my attempt at a portable mast application. </div></div>