PC board milling?

[William Danielson]

Some of those machines like that were sold to Vocational schools and 
colleges, if it was sold as a complete machine it might be worth "more" 
to some folks.

The whole 3 axis controller is cheep cheep cheep these days China 
direct......have not shopped hard on the stepper or servo's...but my 
impression is they run a little higher.

On 01/02/2016 04:25 PM, Alex Fraser wrote:
> Here's a small CNC from Craigslist.  It looks Sherline based and of 
> course has an antique controller. I'd offer much less than he is asking.
> http://fredericksburg.craigslist.org/tls/5378052061.html
>
> It's located near Fredericksburg.
>
> -- 
>
>      ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>         No electrons were harmed in the creation of this message
>           --------------------------------------------------------
>   ~~~******************* Alex Fraser *******************~~~
>           --------------------------------------------------------
> [[[[[[~~^^^#___=>>>```/\/\**O**/\/\```<<<=___#^^^~~]]]]]]
>
>
> _______________________________________________
> Tacos mailing list
> Tacos at amrad.org
> https://lists.amrad.org/mailman/listinfo/tacos

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.amrad.org/pipermail/tacos/attachments/20160103/b6e51927/attachment.html>